Belting - Open Ended - 4 Meters Pitch:3 A single-flute bit for using

A single-flute bit for using when cut speed is more important than cut finish

These stepper motors do not come with cables or wiring attached

- Hardness: HRC 46

26016-03 Post-Assembly T-Slot Nuts M5

Belting - Open Ended - 4 Meters Pitch:3 A single-flute bit for usingThe GT2 series of belts (26053 03) are designed specifically for linear motion. They use a rounded tooth profile that guarantees that the belt tooth fits smoothly and accurately in the pulley groove, so when you reverse the pulley direction, there is no room for the belt to move in the groove. The most up to date X Carve uses part 26053 04, 9mm wide 3GT belts. This belting is meant to be used in conjunction with a timing belt pulley such as these